![vicbuilder](/img/default-banner.jpg)
- 97
- 1 132 337
vicbuilder
Приєднався 23 лют 2010
Video's from The Vic Shop, a performance shop that works on all Victory Motorcycles, all the time!
Відео
Victory speedometer needle is erratic
Переглядів 8983 місяці тому
Victory speedometer needle is erratic
Setting Throttle Position Voltage 2008-2017 Victory
Переглядів 1,4 тис.3 місяці тому
Setting Throttle Position Voltage 2008-2017 Victory
Hogged out rear Victory wheel and bearing
Переглядів 1 тис.4 місяці тому
Hogged out rear Victory wheel and bearing
Victory engine transmission rebuild: Part 4 of 4, Engine Install and Break-in
Переглядів 1,3 тис.4 місяці тому
Part Four of Four
Victory engine transmission rebuild: Part 3 engine assembly
Переглядів 1,5 тис.4 місяці тому
Part Three of Four
Victory engine transmission rebuild: Part 2 cases and transmission
Переглядів 2,4 тис.4 місяці тому
Part Two of Four
Victory engine transmission rebuild: Part 1 Teardown
Переглядів 3,6 тис.4 місяці тому
Part One of Four
1999-2001 Victory 38 Amp Alternator Upgrade Kit Contents
Переглядів 5305 місяців тому
1999-2001 Victory 38 Amp Alternator Upgrade Kit Contents
Victory Vision fuel pump diag and replacement
Переглядів 2,6 тис.8 місяців тому
Victory Vision fuel pump diag and replacement
Victory 2005-2007 100" Performance
Переглядів 1,4 тис.8 місяців тому
Victory 2005-2007 100" Performance
Vic Shop Fuel Pump rebuilds - Cost and Time
Переглядів 1,3 тис.8 місяців тому
For my rebuilding service for the 2002-2008 Victory fuel pumps.
Victory Output Shaft pulley drivetrain click
Переглядів 6 тис.10 місяців тому
Victory Output Shaft pulley drivetrain click
Engine swap video complete
Переглядів 1,9 тис.Рік тому
Tips for swapping engines in 2008-2017 Victory's
Victory Hydraulic Clutch Service from The Vic Shop
Переглядів 4,2 тис.Рік тому
Victory Hydraulic Clutch Service from The Vic Shop
Where to buy Victory parts. Victory parts lookup for pros.
Переглядів 3,1 тис.Рік тому
Where to buy Victory parts. Victory parts lookup for pros.
Victory Fuel Pump Remove and Replace 2002-2008
Переглядів 14 тис.Рік тому
Victory Fuel Pump Remove and Replace 2002-2008
How to Maintain your Cross Country (or other 08 and new Victory) tune up, service, look over
Переглядів 30 тис.Рік тому
How to Maintain your Cross Country (or other 08 and new Victory) tune up, service, look over
A walk through The Vic Shop, December '22
Переглядів 3,8 тис.Рік тому
A walk through The Vic Shop, December '22
Introducing the new Vic Shop Forums!
Переглядів 5 тис.2 роки тому
Introducing the new Vic Shop Forums!
Victory Jackpot engine removal time-lapse
Переглядів 2,3 тис.2 роки тому
Victory Jackpot engine removal time-lapse
Installing Cams on a Steel Frame Victory
Переглядів 3,1 тис.2 роки тому
Installing Cams on a Steel Frame Victory
Victory Vision brakes and Victory brake bleeding REVISED
Переглядів 8 тис.2 роки тому
Victory Vision brakes and Victory brake bleeding REVISED
The Vic Shop, Profile of a Repair 2, Red Kingpin
Переглядів 4,9 тис.2 роки тому
The Vic Shop, Profile of a Repair 2, Red Kingpin
Victory Primary Cover Identification from The Vic Shop
Переглядів 2,1 тис.2 роки тому
Victory Primary Cover Identification from The Vic Shop
best shock for a victory v92tc 2004
My bike will not start
My voltage raider blew out on my 2009 Vegas jackpot, I put a new voltage regulator on it but it blew the fuses and some other things the fuel pump comes on and the bike will crank.
Just bought a 2000 v92c. Going to use this video a lot in the future I’m sure. Very helpful information here. 10/10 video
Great tips, thanks Rylan!
You should have let us listen to it.
Great video! Both my 2016 Vision and 2016 Magnum needed new fuel pumps under 10,000 miles. I bought them used and the previous owners didn't ride them and let them sit with ethanolated fuel in the tank for extended periods. Filter degraded and the pump sucked in the crap. Not Victory's fault but cured my issues.
Anything on replacing fuel pump on 2013 highball? I’m not hearing it cycle when I turn the key on and I’m just cranking. Fuse also looks fine.
On my 1999 vict 92 my speedo and tach doesnt work
What's wrong with the speedo and the tachometer on my 99 victory 0:31
Are Victorys assembled with metric size bolts and nuts?
I had watched several videos on tension and alignment, but never got an explanation for alignment beyond "mess around with the left adjuster". These videos did not show their "messing around". I was very pleased to see your explanation and adjustment on this video. Thanks.
I have a 2000 V92C, that was sitting for years, I got it running, the bike starts, runs for a few minutes until warm, then starts to cut out and dies. What should I look for to fix the issue?
Same issue here, ever get it fixed?
He had it on a conservative tune, then just hit the switch for aggressive tune, probably increased boost. They make over 200 regardless what they are trying to say. 😆
There is not such a thing belt in the middle. It has to be towards left.
Great info, thank you!! 👍👍😎
I totally agree with Ryan,,, I had an issue and I contacted him about an issue I had with my 106 vegas 8ball and he said I can't diagnose if it's not in front of me, I explained I'm in Northern Ireland hoping he would advise possible causes to the problem that I was having with my bike, he never replied, I was left high and dry with no advice and ended up having to scrap my favourite cruiser... But on the flip side I bought with the money from insurance a 20p8m109r and a cosmetic damaged 2011 vegas 8 ball..... So win for me..... Than dude
Thanks Rylan problem fixed and I got cams while I’m at it your the mvp sir
Left out the starter switch on the handle bar.
How about you make a video for all the rebuild guys Ryan and relieve some of us... Show a video on how to rebuild properly in a reasonable time frame! 😉 That would not stop a lot of people but give them the motivation to want to make it easier!! Show us a better way! 💯
Can you still fix this issue
I have a 2011 Cross Country starts and runs good but when engine is hot it will die when you stop at light and have to restart any thoughts on this issue
What are the repair tools you need to replace the ignition assembly and also to remove the seat to replace the battery?
Thank You So much Man. I’m about to do a throttle body adaptor change right now On my 07 8Ball. Much appreciated for this video. Lmfaooo and I always thought that was a choke. Dammnnnnn. I wish you were closer to RI because I can’t figure out why my right side blinkers stopped working.
❤easy fixes❤️😊
i hate that acm
Would putting a big bore kit fix this problem
i want to see another race!!
What about getting to much pressure 70psi
❤Insane❤
Ive got a squeek thats been driving me nuts! Never thought about belt alignment as the cause. I know what im checking tomorrow morning!
As a new 07 jackpot owner, i LOVE your channel. Thanks so much for posting this.
Best video of watched on belt tension . . Cheers
Good morning, The fuel gauge on my 2012 cross country is out of order. Would it be possible to buy one for you with shipping costs to France? Awaiting your reply. Patrick
I have a question I have a 07 victory vegas 8ball.what kind of odb2 scan tool can I use?
Thanks Rylan hope all is good in Iowa
What brand supercharger is on this victory
How do you test fuel pressure on a 2016 victory cross country
Love it
is it the same on a Gunner?
How long did it take?
Rylan did my '09 Vision, cams, pipes, tuned, controller, 1/4 turn throttle, and WOW went from great to holy s***!
I have an issue where my 2013 Boardwalk fuel pump won’t prime. After watching this video, I tired the blinkers and found that when attempting to use them (key on, in run mode, in neutral) the engine relay would buzz. Seems like also need to replace my led flasher relay. What I don’t understand is why the flasher relay affects the main engine relay. Also, the fuel pump will intermittently work, o noticed it would come on sometimes when I pull the clutch. Pretty wild.
Ok so I bought a what is titled as a 2000 victory v92c it had a frame swap to a v92sc as far as I was told. I've been reassembling and rebuilding things over the past Year and have replaced the entire fuel system as far as hoses and main fuel filter, I have not replaced the fuel pump. It wants to kick over but won't. The starter motor is turning over and it fired twice but won't get running. Any ideas? Thanks!
Can you do a full video on how to replace it
Guys, you just put my mind at ease on several questions I had on my 2014 CC. Thank you and i hope to make it to the shop if its still open someday!
In diagnostic mode, are the idle screw adjustments cumulative, or are you always starting from the same fuel level.
This is probably the only V92 that i like, and i like this one a LOT! This thing came out so wicked man!
Sorry Bro, it's not "veneer" it's "vernier"
Can someone do a video on how to replace the rocker arm
Have you found any videos on how to replace the rocker arm yet? I've got the same problem with my Vic..
@@paulzeigler1075 no I have not I’m just taking it to a shop to get it fixed don’t have a choice
@@Trump_train_2024 understand; whatever it takes to get it back on the road, right? Good luck with it and ride safe!
@@paulzeigler1075 thanks brotha and yea I don’t want to just to save money but if it helps when it’s done I’ll let u know what it cost me I did buy the gaskets and the rocker arm my self so I can only getting charged labor